jactionscripters.com

Home > Error Code > Windows Setup Xp Error Code 7

Windows Setup Xp Error Code 7

Contents

I'm not sure if this is a laptop only problem. Error code 4. The error code is 7." History: I built my computer in Spring 2003, Windows XP SP2 and everything was fine until recently. I hooked up an external CD-ROM and XP loaded fine.Thanks for your help. http://jactionscripters.com/error-code/windows-setup-error-code-7.php

The error code is 7. >Setup cannot continue." >According to the Micrtosoft knowledghe base this is a >problem when upgrading from Windows 98 or ME -- but I'm >not! I'll worry about it later. (error code 7) I began doing research, and I strolled across archives of forums with the same problem, almost all of them saying, "check your RAM". I do so, but my windows setup locks up at the kernel debugger loading step, "File Setupdd.sys could not be loaded. I'm working under the assumption you have the real bona fide XP SP2 CD that Microsoft made.

File I386 Ntkrnlmp.exe Could Not Be Loaded The Error Code Is 7

Posted: 09-03-2003, 09:08 PM A further note to my problem: The Intel processor is a hyperthreading one, but I have turned this feature OFF in case it was confusing the XP I've been trying to install my copy of Windows XP Pro, and everytime i get into setup I get one of these errors. sir what I do please tell ma I am very thanful to you Helpful +9 Report Guest Apr 25, 2009 12:40PM I had the same problem. As soon as I changed jumper to Cable Select on one of the DVD drives I was able to install XP.

suddently I remembered about a discussion board on net .. Bios update and memory replacement didn't help so I started taking everything apart and noticed that both DVDROM jumper setting were set to slave. You may receive the following error message during the installation of Windows XP, if the BIOS on your system has problems when Advanced Configuration and Power Interface (ACPI) is enabled. Ntkrnlmp.exe Windows 2008 For Windows XP without SP2 http://support.microsoft.com/kb/555531/en-us For Windows XP with SP2 http://support.microsoft.com/kb/887675/en-us ozrom1e, Nov 5, 2006 #2 xhuwin Thread Starter Joined: Nov 5, 2006 Messages: 2 ozrom1e said: "Windows could

I've never worked on laptops before, so I'm new to these problems. Has anyone found a way out? But when I tried to run windows, it crashed (Missing System32/drivers/NTFS.sys). http://www.realgeek.com/forums/cant-install-due-to-error-code-7-a-74771.html The problem is that I can't get to those stages because windows locks up at 2] To repair a Windows XP installation using Recovery Console, press R. [without sp2] and before

Nicholas David Guest Posts: n/a Can't Install due to "error code 7"! Ntkrnlmp.exe Windows 7 I delete the old one, create it anew and then it will format it for me.2. When I put everything back, my computer couldn't get into BIOS; I got repeating long beeps while posting (memory error). You can search for and download a BIOS update from your computer or motherboard manufacturer's website.

  1. Setup cannot continue.
  2. The error code is 7. -or- The file I386\L_intl.nlf could not be loaded.
  3. Password Site Map Posting Help Register Rules Today's Posts Search Site Map Home Forum Rules Members List Contact Us Community Links Pictures & Albums Members List Search Forums Show Threads
  4. Other CDs can do odd things.
  5. I picked important files and format the partition.
  6. I'm trying to make an original clean installation >| of XP from a new CD. >| How do I get around this? >. > David David Guest Posts: n/a Can't
  7. The error code is 7.

Error Code 7 In Xp Installation

Responses to "Can't Install due to "error code 7"!" David Nicholas Guest Posts: n/a Re: Can't Install due to "error code 7"! Try too remove one of them, it helpt me Helpful +15 Report Ajay Tyagi Jul 20, 2009 11:57PM I have PIII system... File I386 Ntkrnlmp.exe Could Not Be Loaded The Error Code Is 7 Can't Install due to "error code 7"! File Ntkrnlmp Exe Could Not Be Loaded The Error Code Is 4 Finally, save and exit from the backup.

I searched and found the solution. weblink I connected the hardrive to the computer and changed the BIOS to run from cd (mesh computer recovery cd). So, after checking the RAM and hard drive, it turned out to be a faulty CD-ROM drive. I'm thinking it's a motherboard problem because everything else seems to be working. Setupdd.sys Error Code 4

The error code is 7. >| Setup cannot continue." >| According to the Micrtosoft knowledghe base this is a >| problem when upgrading from Windows 98 or ME -- but I'm It just gives me that same error over and over when I try to boot from the CD. Privacy Policy Ad Choice Terms of Use Mobile User Agreement cnet Reviews All Reviews Audio Cameras Laptops Phones Roadshow Smart Home Tablets TVs News All News Apple Crave Internet Microsoft Mobile navigate here Thanks in advance.

The box below showed that there are all 'unknown disks' I pressed enter to set up windows xp and the blue screen came up with the following error: Setupdd.sys: Page_Fault_In_Nonpaged_Area Does Ntkrnlmp.exe Windows 10 Then when this is done return it to the original computer as a master drive on the primary IDE cable and do the following: I hope you have the Windows software call (425) 635-3311. > > >-- >Nicholas > >--------------------------------------------------------- --------------- > >"David" wrote in message: > news:[email protected] > >| I've just assembled a brand new computer utilizing an >| Asus

sign-up, it takes less than a minute and it's free!

Copyright 2014 All Enthusiast, Inc Powered by: vBulletinCopyright ©2000 - 2016, Jelsoft Enterprises Ltd. Now, after I put the store-bought RAM in, I could post, could get into BIOS, etc. load needed DLLs for kernel Very VERY Awkward Win7 on Macbook Pro with Mac OS X... [SOLVED] Internal HD Used as External HD Fps drops with core clock drops on... » Ntkrnlmp.exe Download The error code is 7. "Ntkrnlmp.exe Could Not Be Loaded.

and installed XP very smoothly... I'm pretty sure its not my windows cd because its a legit copy, and i dont think its the hardrive either because this is the second one ive bought in hopes I'm trying to make an original clean installation >of XP from a new CD. >How do I get around this? >. > David Nicholas Guest Posts: n/a Re: Can't Install http://jactionscripters.com/error-code/windows-setup-the-error-code-is-18.php BTW my XP is a legit copy, bought it with a 300g PATA seagate.

The Error Code Is 7" Error Message Occurs During Windows Setup Reply Reply With Quote April 29th, 2009,03:23 PM #8 flyhigh View Profile View Forum Posts View Blog Entries Junior Double-click on Computer, and then double-click on Advanced Configuration and Power Interface (ACPI) PC to open its properties dialog box. I replaced the HDD, ran some scans to make sure the HDD was efficient, and began my install of Windows XP Professional. Note: The key to enter BIOS setup is different for different computers.

I look around online, and others said to try repairing with the Windows Setup CD. I'm trying to make an original clean installation >of XP from a new CD. >How do I get around this? >. > David LinkBack Thread Tools Display Modes « Reply Reply With Quote February 9th, 2007,01:23 AM #5 darkensi View Profile View Forum Posts View Blog Entries Junior Member Join Date Feb 2007 Posts 4 sorry sorry for bumping I hope that helps.

and The file I386\Ntkrnlmp.exe could not be loaded. Setupdd.sys, Error code 7 Discussion in 'Windows XP' started by xhuwin, Nov 5, 2006. The error code is 7."). Join over 733,556 other people just like you!

Thanx jax See more Error code 7 in xp installation Error code 7 when installing window Windows xp installing error code 7 Unable to Install windows XP over windows 7 [Solved] I never format the drive ahead of the reinstall. Error code 7. Posted: 09-03-2003, 06:12 PM Troubleshooting Windows XP Setup http://www.kellys-korner-xp.com/xp_setup.htm Microsoft Support: In the U.S.

I get both: Setupdd.sys could not be loaded. Press any key to exit. Even "copies" vary so be exact here.BobPS> We can see wipe the drive clean with DBAN (see google.) Flag Permalink This was helpful (0) Collapse - Re: by deacon34 / July