jactionscripters.com

Home > Windows Xp > Windows Xp Error When Shutting Down

Windows Xp Error When Shutting Down

Contents

Before I Begin Before I get started, I want to point out that the techniques in this article are intended for use primarily on Windows XP. If you think that your system’s hardware may be to blame then you will have to use trial and error to locate the offending device (or devices). Please follow sensible Registry editing protocol. For example, I recently helped a friend install Windows onto a new computer.

SOLUTION: He removed all drivers, and put back only the digitally signed one. Smith reported a more obscure cause of slow shutdown: In Win XP Professional, the Group Policy Editor has a security option to clear the pagefile at system shutdown. Some problems especially appear where multiple users are enabled on the system and one switches between users during a single Windows session. Transcript The interactive transcript could not be loaded. check over here

Windows 7 Shutdown Problem

If the fix doesn’t work for you, remove it by restoring the Registry to its prior state. (For those who want more background information, the fix provided by this patch is The entry (or entries) with the name ctfmon should be left as well as PrintDisp, which has to do with printing. The links page just mentioned provides a 10-step approach to troubleshooting STOP Messages in general, then itemized analysis on the most common of these. (STOP messages are identified by an 8-digit

To change the setting, click Start | Run, type GPEDIT.MSC, click OK. What do I do? Here’s what they have reported: CD-ROM DRIVE: Samsung 24x. Windows 7 Won't Shutdown Properly To disable Terminal Services, follow the steps in the prior paragraph for launching SERVICES.MSC.

MOVE THE PAGEFILE? Windows 7 Not Shutting Down Properly Save and exit the registry after you are finished. The solution is to get the updated TPKD.SYS file from PACE.

However, it is now available on the Windows Update site under “Recommended Updates” for Win XP Professional, titled “Restarting Windows XP.” As a workaround, newsgroup correspondent “lou” resolved this problem by

Double-click to expand Universal Serial Bus Controllers. Windows Xp Automatic Shutdown Problem Site visitor Jim Porter found that his Asus P5GDC-V Deluxe motherboard had a "wake on" setting in Device Manager | Properties | Advanced rather than in the BIOS or Power Management Correspondent "Curiefleas" wrote that his reboot-on-shutdown problem was solved when he used a third party partitioning program to convert his NTFS partition to FAT32. This freezes up, or at least significantly delays, Windows shutdown.

  • Bios Problems: The system restarting continuously some times may have a bios problem in it.
  • When the WaitToKillAppTimeout computer registry entry timeout or ends, the End Task discussion box appears, stating that the process did not respond, and allowing customer to End the process.
  • Method 2 Checking Registry Entries 1 Open the Registry Editor.
  • For a step-by-step troubleshooting method that applies to all versions of Windows 9x, see the generic Windows Shutdown Troubleshooter.
  • The first time this happens, users might assume they accidentally selected Restart instead of Shut Down from the drop-down menu in the Shut Down Windows dialog box—a common mistake.
  • Home > Articles > Shutdown > Here WINDOWS XP SHUTDOWN & RESTARTTROUBLESHOOTING Version 13.8 -- March 5, 2007 Hold mouse here for list of most recent changes.

Windows 7 Not Shutting Down Properly

we will take a look at driver issues and chkdsk /r /f /x and we will also take a look at sfc /scannow. their explanation Stop 0x9F and Stop 0x8E are two of the most common of these at shutdown, and generally point to a bad driver. Windows 7 Shutdown Problem The default value in this dialog box is 20000, which is 20 seconds expressed in milliseconds. Windows Xp Shutdown Problem Patch Correspondent Bill Anderson (based on a solution by "Willy") gave a lengthy description of how to do this, edited a little for space reasons. (Thanks also to correspondents Ward from Belgium

SOLUTION: Uninstall Video Pack 5 and also delete CDRALW2K.SYS (Tip from Christian Männchen). However, this is one of those cases in which an updated video driver usually solves the problem. Eventually, an "End Task" window appears, wanting to terminate DEVLDR32.EXE. Software Problems: Most of the problems restart problems occur due to the junk files which corrupt the registry and make the system to get into fatal errors which are very problematic Windows 7 Cannot Shutdown

When he resolved the mismatch (by removing the PC-100 RAM), he also resolved the shutdown problem. Win XP Setup says it's checking hardware. They can be downloaded here. (Tip from Mark Gillespie.) NOTE: This same problem has been reported for the Creatix V.90 Ham PCI Modem. (Tip from Marco Nolte) MODEMS: Billion BIPAC In a domain environment, don't forget to check any logoff scripts you are pushing.

Many people have reported that this has solved their shutdown problems (and had other advantages) with Win XP, just as it has in earlier versions of Windows. "ShutNTdown" REGISTRY PATCH. Windows Xp Shutdown Repair Tool USING SHUTDOWN SCRIPTS & 802.1x AUTHENTICATION PROTOCOL. The Windows Setup Dialog Box describes the Recovery Console option.

Many people have claimed that the Nvidia Driver Helper Service (used with Nvidia video cards) causes extremely slow shut downs.

Then get around to HKEY_USERS\.DEFAULT\Control Panel\Desktop\ computer registry division, and do identical as above to modify and modify the value of WaitToKillAppTimeout and HungAppTimeout computer registry keys. Hardware manufacturers frequently revise drivers when bugs are discovered. SHUTDOWN PROBLEMS IN WINDOWS 9x. System Shutdown Automatically Windows Xp If you really have a hardware inability to powerdown, these won’t solve it; but for some other underlying causes of powerdown failures, they just might.

At shutdown, the driver tries to run from the same memory space DEP monitors. UQHDGAMER 68,734 views 9:22 Fixing Windows 7 Start-up Problems - Duration: 2:27. If you have Office XP installed, the culprit may be CTFMON.EXE. You may have to try repeatedly, or try pressing F6 and F5 repeatedly. – JAE] When successful, you’ll see a two-paragraph instruction that begins, “To specify additional SCSI or other mass

If you have Nero CD-burning software (versions 5.0-5.5) installed on your computer, and invoke Standby or Hibernation modes more than once in a Windows session, the computer will hang on the Finally, deselect the Automatically Restart check box, shown in Figure A, and click OK. Correspondent Morten Bech reported that a combination of PC-100 and PC-133 RAM was the source of his shutdown problem. SOLUTION: Billion has now released a new driver 3.24 that solves this problem, available here. (Tip from Leo Foederer.) MOTHERBOARDS: Asus P2B-F, P2B-VM, or P2L97.

Safe Mode can reboot the PC with a minimal set of device drivers and services to start Windows before the problem has been solve. 2 Reboot PC from Safe Mode. You can decrease the hang on here we are at Windows to murder the persistent solutions. Once the system hangs, pressing [Ctrl][Alt][Delete] has no effect. Flag as...

Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... Slow shutdowns are mostly caused by having too many programs loaded that have to be terminated during the shutdown process, many of which are usually loaded at startup. About this wikiHow How helpful is this? For full instructions, plus more information on the file and its function, see What Is CTFMON and What Does It Do? (Tip from Jay Jones) VIA Apollo Pro 133 motherboards

Mysimplefix 795,783 views 3:42 How to Speed up Windows 7 Start up and shut down time - Duration: 9:22. The newer version 4.3 SAUSB.SYS driver from Lexar's Web site works perfectly, and does not cause a shutdown problem. (Tip from correspondent Eric Brown.) Though one correspondent reported that the even There is a problem with the SAUSB.SYS file, apparently part of the Win98 SE driver set for this device, retained during an upgrade to Win XP. However, if it happens repeatedly and a blue STOP error screen appears for just a moment before the system restarts again, the system possibly has a CDR/CDRW drive using Roxio Easy

Correspondent Bill Anderson (based on a solution by “Willy”) gave a lengthy description of how to do this (edited a little bit for space reasons): Boot the computer from the Save your settings. However, other factors can sometimes interfere with correct powerdown functioning. When you do, you will see the network card’s properties sheet.

Once you change the value, click OK, close the Registry Editor, and then restart the system.I suggest starting with a five-second change and then testing the shutdown procedure to see if Sign in to make your opinion count.